水井液位监测：静水位、动水位与采购记录

A documented application, not a claimed WESIVO installation

KELLER 压力's public water-well application describes observing both static and pumping water 液位s, with 流量 information helping interpret well and pump behaviour. This establishes a real 工业 setting; it does not identify a WESIVO customer, installation result or guaranteed saving.

This article is an application-planning note. The enquiry and handover framework below is our editorial guidance for a separate proposed project, rather than a retelling of an unverified customer success story.

Describe the readings before selecting the 仪表

Record whether a reading was taken with the pump stopped, during pumping or during recovery. Include the time and operating condition instead of treating every sample as directly comparable. Agree with the well operator how these states will be identified and how the record will be used.

Distinguish depth to the water surface from liquid column above the sensing diaphragm. A deep well does not automatically require a 压力 range equal to the full well depth. Provide a drawing showing the wellhead reference, proposed sensing point and expected water positions. The existing datum and density guide explains these geometric relationships separately.

Build one enquiry sheet for the entire measuring point

• Identify the well tag, access dimensions and agreed reference elevation.
• Provide available stopped-pump, pumping and recovery observations with their conditions; mark unknown information.
• Specify the proposed probe location, expected immersion envelope and the basis for the requested measuring span.
• Describe the water, 温度 and any known sediment or chemical exposure; request compatibility of the complete wetted assembly.
• Show the cable route, required length, support and retrieval arrangement, termination position and potential flooding exposure.
• Identify the selected signal, receiving input and recording needs, including who supplies the logger or communications equipment.

Have the responsible well team define the required operating limits. This article supplies no pump stop/start thresholds or protective-control design.

Include the dry end in the installation review

Confirm the ordered 压力-reference arrangement. If a probe uses a vented reference cable, obtain its termination and moisture-protection instructions. WIKA's cable guidance addresses moisture pathways at the cable end; a submerged probe rating alone is not a complete termination specification.

Ask the supplier to identify any required enclosure, 压力-equalising element or serviceable accessory by the exact configuration. Record ownership of inspection and replacement tasks. Do not prescribe cable cutting, splicing or sealing from a generic website note.

Agree the handover evidence

Retain the probe identity, cable specification, sensing elevation, receiver settings and drawing revision together. Agree a suitable independent 液位 comparison with the operator and record the method, time, pump state and observations. Log gaps and unresolved differences rather than declaring the whole pumping system validated from one plausible 液位 reading.

Discuss a WESIVO configuration

The current SL09A product entry and original WESIVO 液位 catalogue are starting points for a submersible-仪表 enquiry. Submit the completed sheet, quantity and destination, and ask for written confirmation of the selected reference method, materials, cable, output and required documentation.

The catalogue link does not establish drinking-water approval, an included vent accessory, telemetry, automatic pump control or suitability for this well. Those requirements need configuration-specific confirmation.