Translate the process requirement into a specification
A 卫生型 process installation needs more detail than a sanitary product name. Describe the food, beverage or other process medium, 温度, 压力 and cleaning procedure. Separate ordinary production conditions from cleaning conditions, and identify the documentation required by your equipment specification or quality system.
Match the physical connection
Send the mating fitting drawing, clamp standard, size, gasket requirements and available installation envelope. The WESIVO 720HY catalogue identifies a Tri-Clamp 压力-transmitter arrangement. Confirm its exact connection drawing rather than assuming that equal nominal sizes from different standards will match the installed fitting.
Review 温度 and wetted parts
The TT30E is a WESIVO sanitary 温度-transmitter candidate. Review insertion length, sensing location and the mechanical arrangement alongside the 压力 point. Ask for confirmation of wetted materials, surface requirements and cleaning 温度 limits for each ordered configuration. Do not infer 卫生型 certification or cleaning compatibility from the connection style.
Create a review package
Send the process and cleaning schedules, fitting drawings, signal requirements, quantity and required certificates. Request written confirmation of the chosen configuration before ordering. During assembly, check that the installed orientation, gasket and probe dimensions match the approved drawings and that the final 仪表 tags correspond to the control-system list.
将工艺需求转为选型条件
卫生工艺选型不能只看产品名称。应说明食品、饮料或其他工艺介质、温度、压力及清洗过程，并分别列出生产和清洗工况，明确设备规范或质量体系要求的文件。
核对实际连接尺寸
提供配对接头图、卡箍标准、尺寸、密封垫要求及安装空间。WESIVO 720HY 样册列有 Tri-Clamp 压力变送器结构，应核对具体连接图，不可仅凭不同标准下相同的公称尺寸认定可安装。
核对温度和接液部件
TT30E 可作为 WESIVO 卫生型温度变送器的选型入口。温度点需结合压力点核对插入长度、测温位置和结构。每个配置都应确认接液材质、表面要求及清洗温度限制，不能根据连接形式推定卫生认证或清洗兼容性。
形成可核对的询价资料
询价时发送生产与清洗条件表、接头图、信号要求、数量和所需证书，订购前书面确认配置。装配时检查安装方向、密封垫和探头尺寸是否与认可图纸一致，并核对仪表位号与控制系统清单。
沟通您的应用需求
请提供介质、工况、连接、输出、数量及收货地区，WESIVO 将在报价前核对配置。