Separate 差压 and line 压力
The 压力 drop across a filter is different from the 压力 carried by the pipeline. Provide normal and maximum line 压力 as well as the expected clean-filter and service-limit 差压 压力s. A suitable 差压 span alone does not establish that an 仪表 is suitable for the full static 压力 of the process.
Describe the actual operating sequence
Include filter type, liquid or gas, operating 温度 and whether the system has backwash, switching or rapid 阀 operations. Tell WESIVO if reverse 差压 压力 can occur. Ask the system designer to define alarm thresholds; a transmitter reading alone does not determine when a particular filter element must be replaced.
Review the WESIVO 仪表 configuration
The 730E is a 差压变送器 with an isolation diaphragm. The 780C family includes 智能 差压 压力 and seal configuration options. Confirm the selected model's static-压力 limit, wetted materials, process connections, output and mounting arrangement from the quotation and applicable data sheet.
Plan installation and commissioning
Provide the tapping-point layout and proposed manifold or impulse-line arrangement for review. Label high and low sides, plan service access and follow the 仪表 instructions for isolation and equalization. During acceptance, verify the clean-filter baseline at a documented 流量 condition so later readings can be interpreted in context.
区分差压与管线静压
过滤器前后的压力差不等于管线本身的压力。请同时提供正常和最高管线压力，以及洁净滤芯和维护限值附近的差压。差压量程合适，并不代表仪表能够承受过程的完整静压。
说明实际运行顺序
说明过滤器类型、液体或气体、工作温度，以及反冲洗、切换和快速阀门动作等运行过程。可能出现反向差压时应明确说明。报警限值由系统设计方确定，仪表读数本身不能决定某种滤芯的更换周期。
核对 WESIVO 仪表配置
730E 为带隔离膜片的差压变送器；780C 系列可进一步核对智能差压与密封配置选项。应通过报价配置和对应数据表确认静压限制、接液材质、过程连接、输出与安装方式。
安排安装和调试
提供取压点及拟用阀组或引压管布局，标记高低压侧并预留维护空间。隔离和平衡操作应遵守仪表说明。验收时，在记录明确的流量工况下建立洁净滤芯基准，便于后续对比。
沟通您的应用需求
请提供介质、工况、连接、输出、数量及收货地区，WESIVO 将在报价前核对配置。